Group Selection - AUDIOropa xepton RX-1 Mode D'emploi

How to use
2.2 Power ON / OFF
Slide the ON/OFF switch upwards to switch the
device on. The LC-display will light up and the
currently selected group number is shown.
To switch the device off after use: Slide the ON/
OFF switch back to the lower position.
2.3 Reception
Reception will start as soon as the device is swit-
ched on. The symbol indicates the incoming
signal strength.

2.4 Group selection

Switch the device off. Then press and hold both

the » « and »  « buttons while switching the
device on.
The symbol „GRP« in the display will blink. Select
a group number of your choice between 00 and 39


by pressing the » « and » « buttons.
After the selection, wait for 5 seconds to set the
chosen group number.
The »GRP«-symbol will stop to blink and the selec-
ted group number is displayed.
English 15