Cleaning And Maintenance - VelLight LEDC25 Mode D'emploi

Dynamic Mode
Use DIP switch 8 (sudden colour change) or 9 (gradual colour change) to
activate the dynamic mode. DIP switches 1 to 7 will then act as speed
values.
DIP1 DIP2
speed1 speed2
When several DIP switches are on, the DIP switch with the highest value will
suppress all others.
7.2 DMX Mode
The DMX mode allows you to control your LED strips through a DMX
console. To do so, connect your console to the DMX input of the LEDC25.
Refer to page 2 for a connection example.
You will also have to determine the DMX start address for each LEDC25.
Refer to the table below.
DIP1 DIP2
1 2
Example: Switches 4, 5 and 7 are on, the DMX start address will be 88
(8 + 16 + 64).
7.3 Fun Mode
The FUN mode allows you to determine the data transfer speed. Slide DIP
switch 10 to on for low speed transfer at 400 kbps or off for high speed
transfer at 800 kbps. We recommend setting the controller at 800 kbps
when using the Velleman

8. Cleaning and Maintenance

 All screws shall be tightened and free of corrosion.
 The electric power supply cables must not show any damage. Have a
qualified technician maintain the device.
 Wipe the device regularly with a moist, lint-free cloth. Do not use
alcohol or solvents.
 Do not immerse the device in any liquid.
 There are no user-serviceable parts, apart from the fuse.
 Contact your dealer for spare parts if necessary.
V. 02 – 22/10/2015
DIP3
speed3
DIP3 DIP4
4 8
® LQ12N210DRGB LED strip.
LEDC25
DIP4 DIP5
speed4 speed5
DIP5 DIP6
16 32
7
DIP6
speed6 speed7
DIP7 DIP8
64 128
©Velleman nv
DIP7
DIP9
256