Saey PEAK Notice D'installation Et D'utilisation page 54

Installing the stove adapter when choosing top connection
1) Back wall / heat shield must be taken off – 2
screws M6 x 8 mm
2) Remove the small round cover on the top.
Go through the opening at the back side and screw
off the hex bolts.
3) Install the small cover at the back side of the stove, by
using the hex bolts and clouts
54
Fig 4.4 take off the back wall
Fig. 4.5 Remove the small round cover at the top
Fig 4.6 Install the cover at the back side