Sony DPS-V55M Mode D'emploi page 16

Editing a Program
Saving your Program
New programs created by changing effect blocks, effect structures, and effect parameters can be stored in memory for later
use. You can store up to 200 different user programs using program numbers 201~400.
1
Press SAVE to activate the save mode.
The program number starts blinking.
(A previously saved program name appears in the
display.)
S a v e :
2 0 1
2
Turn the rotary encoder to select the
program number (201~400) where you
want to save the effect.
(A previously saved program name appears in the
display.)
S a v e :
3 0 0
3
Press EDIT PARAMETER / to move the
cursor to the program name.
The name of the program you edited appears in the
display and the first character starts to blink.
S a v e :
3 0 0
16
GB
S u p e r R e v e r b
S t e r e o C h o r u s
S u p e r D e l a y
Display SAVE
EDIT PARAMETER EXIT ENTER
? / (TAP)
4
Turn the rotary encoder to select a
character.
S a v e :
3 0 0 X u p e r D e l a y
5
Use EDIT PARAMETER ? or / to move
the cursor into place for the next
character.
Repeat steps 4 and 5 to enter up to 12 characters.
6
When you've finished entering the
characters, press SAVE (or ENTER (TAP)).
S a v e : O K ?
N [ E X I T ] / Y [ E N T E R ]
7
The unit will ask for confirmation before
saving the program.
To execute the save operation, press ENTER (TAP).
If you press ENTER (TAP), "Writing..." appears
momentarily, the program is saved, and the unit
switches back to the play mode.
If you do not want to save the program, press EXIT.
If you press EXIT, the unit returns directly to the play
mode without saving the program.
3 0 0 X M y P r o g r a m
F x A : 2 4 / F x B : 3 1
Rotary encoder