Agilent Technologies Truevolt Série Guide D'utilisation Et De Maintenance page 304

Erreurs d'exécution (-200...)
-200,"Execution error"
-203,"Command protected"
-203,"Command protected; external trigger requires license LAN"
-203,"Command protected; License required"
-203,"Command protected; requires license LAN"
-203,"Command protected; requires license SEC"
-210,"Trigger error"
-211,"Trigger ignored"
-213,"Init ignored"
-214,"Trigger deadlock"
-220,"Parameter error"
-221,"Settings conflict"
-221,"Settings conflict; *TRG when TRIG:SOUR BUS not selected; trigger ignored"
-221,"Settings conflict; 10A current terminals not available with rear terminals; terminals set to 3A"
-221,"Settings conflict; CALC function not allowed in current measurement function; CALC:STAT OFF set"
-221,"Settings conflict; CALC not allowed in current measurement function"
-221,"Settings conflict; CALC not allowed in current measurement function; CALC:STAT OFF set"
-221,"Settings conflict; CALC:AVER:STATe OFF set"
-221,"Settings conflict; CALC:TRAN:HIST:STATe OFF set"
-221,"Settings conflict; CALCulate not allowed in current function"
-221,"Settings conflict; cannot delete state selected and enabled for automatic power-on recall"
-221,"Settings conflict; histogram lower range > upper range; CALC:TRAN:HIST:RANG:AUTO ON set"
-221,"Settings conflict; lower limit > upper limit; CALC:LIM:UPP set to CALC:LIM:LOW value"
-221,"Settings conflict; trigger source is BUS"
-222,"Data out of range"
-222,"Data out of range; value clipped to lower limit"
-222,"Data out of range; value clipped to upper limit"
-223,"Too much data"
-224,"Illegal parameter value"
-225,"Out of memory; measurement data overrun"
-230,"Data corrupt or stale"
-231,"Data questionable"
-240,"Hardware error"
-240,"Hardware error; cannot communicate with measurement hardware"
Guide d'utilisation et de maintenance des multimètres numériques Agilent série Truevolt 303