WMF LINEO Mode D'emploi page 10

Start-up
Please clean all parts as described in the 'cleaning and care' section before allowing them to come into
contact with food.
▪ Place the container (2) on the drive unit (5) and lock in place by twisting in a clockwise direction.
Click the container (2) into place.
▪ Remove the protective cover from the stainless steel blade (3) and insert the steel blade (3) into the
slot at the bottom of the container (2) .
Caution: The blade is sharp. For this reason, always replace the protective cover when the blade is
not in use.
▪ Insert the food, seal the container (2) with the lid (1). Place the food in the container (2) no higher
than the MAX mark.
Close the lid (1) by twisting in a clockwise direction, the lid (1) clicks in. Ensure the lid is fitted
correctly (see diagram)
▪ After connecting the mains plug, select the desired speed setting on the speed control (4). Now
briefly press down the impulse ring on the lid (1) several times (see diagram) until the desired result
is achieved.
▪ Always wait for the blade (3) to come to a standstill before removing the lid (1).
Safety function
The motor of the multi-chopper will only start when the container (2) and lid (1) are attached
correctly. Do not remove the lid (1) while the device is operating.
10