Visual Indication - INFOSEC UPS SYSTEM Zen Live 500 Manuel Utilisateur

Masquer les pouces

Table des Matières

Les langues disponibles

U P S S T A T U S I N D I C A T O R S

Z E N L I V E – 5 0 0 / 6 5 0

Status

AC Mode

On Battery

Low battery

UPS is off.

UPS fault

Z E N L I V E – 8 0 0 - 1 0 0 0

Status

AC Mode

On Battery

Low Battery

Battery Replacement

Overload

UPS Fault

7 . I N S T A L L A T I O N A N D O P E R A T I O N

1. Checking

When you receive your equipment, open the packaging and check that your UPS has not

been damaged. Packaging includes: UPS, and a user guide.

In the event of damage, please submit a standard claim to the after-sales service

department.

2. Charging the batteries

This UPS is shipped from the factory with its internal battery fully charged, however, some

charge may be lost during shipping and the battery should be recharged prior to use. Plug

the UPS into an appropriate power supply and allow the UPS to charge fully by leaving it

plugged-in, with no load, for at least 8 hours.

The UPS will automatically recharge its own batteries. You may use the UPS immediately,

however the back-up power capacity may be lower than the nominal value required.

3. Placement & storage conditions

The UPS has been designed to operate in a protected environment, at temperatures

between 0°C and 40°C and at a humidity level ranging between 0% and 90% (no

condensation).

Do not obstruct the ventilation slots. Install the UPS in an environment which is free from

dust, chemical vapours and conductors. Moreover, in order to avoid any interference, keep

the UPS at least 20cm away from the CPU (central processing UPS).

INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com

Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 02 19 AA 59 203 27