Before Installation; Installation Procedure - Toto CST775 Manuel D'installation

Masquer les pouces

Table des Matières

Les langues disponibles

Read these instructions thoroughly before beginning work.

Please leave instructions for customers. These instruction contain maintenance

and warranty information.

If necessary, remove the existing toilet.

IMPORTANT!

Due to the powerful performance of our Tornado, G-Max, E-Max and Power Gravity

ﬂushing systems, they are not speciﬁed for back-to-back installations. The only

means of installing these toilets in a back-to-back situation is when the toilet drain

connections incorporate a WYE ﬁtting. Please contact your builder or contractor prior

to this installation.

For your new TOTO toilet to ﬁt correctly, the rough-in,

the distance between the ﬁnished wall to the center of

the closet ﬂange, must be at least 12 inches for most

models.

NOTE: Models with 10" rough-in have model numbers

ending with ".10", for example C776CEFG.10.

1) Clean any debris out of the closet ﬂange and then install

new mounting bolts (not supplied) into the slots of the

closet ﬂange (see ill. 1). The head of the bolt should be

inserted into the slot with its threads facing upward.

2) Carefully turn the toilet upside down onto some padding.

Firmly press a new bowl wax ring (not supplied) onto the

circular recess around the toilet bowl's horn (see ill. 2). Turn

the toilet upright and gently lower into position over

the closet ﬂange. With toilet properly aligned, press ﬁrmly

on both sides of toilet rim to set the bowl wax ring (see

ill. 3).

CAUTION: Do not move the bowl after the

bowl wax ring is set. Thread the nuts and

tighten evenly until bowl is snug to closet

ﬂange. Install the bolt caps (see ill 3).

CAUTION: Do not overtighten the nuts as

damage to the china bowl may result.

NOTE: Rocking may occur depending on the

condition of the ooring. In that case, use

shims to prevent the toilet from rocking.