Italiana Camini Dafne Instructions Pour L'utilisation Et L'installation page 9

FITTING THE CERAMIC TILES
(TAB. 3 pag. 42)
The DAFNE, DAFNE OVEN, NINFA, ELF, ELF OVEN stoves have a metal and cast iron structure with four painted aluminium uprights with groo-
ves for fitting ceramic tiles.
The table below shows the number and type of tiles needed for each model:
DESCRIPTION
A = side tiles
B = front tiles
C = side tiles
D = side tiles
E = front tiles
I = burgundy red full series tiles
L = leather full series tiles
M= beige full series tiles
N = soap stone full series tiles
The stoves are delivered with the ceramic tiles separately packed to avoid breakage and damage during transport.
The rear tile faces may have fine surface cracks, which however do not affect their quality in the slightest.
Unpack the tiles only once they are on the installation site.
Each stove is fitted with its ceramic covering during construction and testing, to make sure assembly is as quick and easy as possible.
The tiles are then removed and packed separately.
Ceramic tile fitting procedure (DIS. 5 pag. 43)
- figure 1 shows the stove as it is delivered
- remove the top by unscrewing the 4 screws (fig. 2).
- slip the front bar out by lifting it (fig. 3).
- slip the tiles in place in the front panels (fig. 4).
- put the front bar back in place as before.
- slip the ceramic tiles into the side guides provided, from top to bottom (fig. 5).
- put the top back on the frame and tighten the 4 screws (fig. 6).
- fig. 7 shows the fully assembled stove.
9