Troubleshooting; Specifications - Sony SS-M9ED Manuel D'installation

Troubleshooting

Should you encounter a problem with your speaker
system, check the following list and take the indicated
measures. If the problem persist, consult your nearest
Sony dealer.
There is no sound from the speaker system.
, Make sure all the connections have been correctly
made.
, Make sure the volume on the amplifier has been
turned up properly.
, Make sure the program source selector on the
amplifier is set to the proper source.
, Check if headphones are connected. If they are,
disconnect them.
The left and right sounds are unbalanced or
reversed.
, Make sure the plus (+) and the minus (–) terminals
on the speakers are matched to the corresponding
the plus (+) and the minus (–) terminals on the
amplifier.
, Check if the speakers and components are
connected correctly and securely.
There is hum or noise in the speaker output.
, Make sure all the connections have been correctly
made.
, Make sure none of the audio components are
positioned too close to the TV set.
, Check if the speaker cords is kept away from any
AC power cords.
The sound has suddenly stopped.
, Make sure the stripped ends of the speaker cords
do not touch each other.
, Make sure the stripped ends of the speaker cords
do not touch neighboring speaker terminal.
14 GB

Specifications

Type
4-way, bass reflex (vented) system
20 cm woofers × 2
Configuration
13 cm midrange
2.5 cm tweeter
2.5 cm super tweeter
Frequency response 26 - 100,000 Hz (±3 dB)
Impedance 4 ohm nominal; 2 ohm minimum
Maximum input power 400 watts
Minimum input power 50 watts
Maximum output 113 dB
Sensitivity 86 dB, 1 meter, 2.83 Vrms
Crossover frequencies 200 Hz, 2,000 Hz, 22,000 Hz
Approx. 400 × 1,125 × 555 mm
Dimensions (w/h/d)
Mass Approx. 58.1 kg each
Supplied accessories See page 5.
Design and specifications are subject to change without notice.