Avdel Genesis nG3 Manuel D'instructions page 47

A c c e s s o r i e s
Preparing the Base Tool for Right-Angle and Straight Swivel Head A t t a c h m e n t
•
Disconnect the air supply.
•
Remove any nose assembly items.
•
Remove Stem Collector Bottle Assembly (71213-05100) or 71210-20400.
•
Replace assembly with Safety Cap (71213-20102 or 71210-20101).
•
Unscrew Jaw Spreader Housing 41 and remove with 'O' Ring 12
•
Remove Locknut 40, 'O' Rings 15 and 19, and Seal Housing 52. Do not refit these items.
•
Screw Stop Nut (71213-20200) onto the front of Head Piston 36 as far as it will go by hand.
•
Refit Jaw Spreader Housing 41 and 'O' Ring 12, tighten onto Head Piston 36, finally tighten Stop Nut against Jaw Spreader Housing.
The tool is now ready to be fitted with a swivel head. Instructions page 16.
Item numbers in bold refer to the general assembly drawing and parts list on pages 24-25.
B a s e To o l 7 1 2 2 3
Base tool to receive a nose assembly
Base tool to receive a swivel head
71213-20200
STOP NUT
B a s e To o l 7 1 2 2 4
Base tool to receive a nose assembly
41 12 40
19
15
Base tool to receive a swivel head
71213-20202
STOP NUT
41 12 40 52
19
15
52
36
71213-20102
SAFETY CAP
36
71210-20201
SAFETY CAP
71210-05100
71210-20400
15