Hama Soundcup-S Mode D'emploi page 6

Note – Bluetooth
• Some terminal devices require a password in order to connect to another
Bluetooth
device.
®
• If your terminal device requests a password for connection to the speaker, enter
0000.
Note
• The speaker always stores the last eight terminal devices paired.
• The speaker will automatically connect to the last terminal device paired when it
is switched on the next time.
4.5 Automatic Bluetooth
• Make sure that your Bluetooth
activated.
• Make sure that the speaker is located within the Bluetooth
metres.
• Switch on the speakers as described in 4.1 Switching the product on and off.
• After successful connection, the status LED (4) will light up in blue. An acoustic
signal confirms that connection was successful.
Note – Connection impaired
• After the speaker and terminal device have been paired, a connection is
established automatically. If the Bluetooth
automatically, check the following:
• Check the Bluetooth
Soundcup-S is connected. If not, repeat the steps listed under Bluetooth
pairing.
• Check whether your terminal device and the speaker are less than 10 metres
apart. If not, move them closer together.
• Check whether obstacles are impairing the range. If so, move the devices closer
together.
• Check whether the audio cable is connected to the speaker. If so, disconnect it.
password
®
connection (after successful pairing)
®
capable terminal device is on and Bluetooth
®
settings of your terminal device to see whether Hama
®
range of max. 10
®
connection is not established
®
is
®
®
5