Hayward SharkVAC XL Pilot Guide De L'utilisateur page 26

7. After the pool has been cleaned, switch OFF the power supply before removing the cleaner from the
pool.
8. Remove the cleaner from the water at the shallow end of the pool by pulling the cable until the cleaner
reaches the surface. Then lift it out of the water using the handle, NOT the cable.
9. If the supply cord is damaged it must be replaced by the manufacturer, service agent, or similarly
qualified persons in order to avoid a hazard.
10. All electrical connections must be done by a qualified electrician according to local electrical standard
(see p17).
Caution: When pulling the cable, reel it in hand-over-hand - do NOT reel it around your arm.
DO NOT ENTER THE SWIMMING POOL WHEN THE CLEANER IS OPERATING.
Optimum operating water temperature range for the cleaner is 10ºC - 35ºC.
Remove the cleaner from the pool after each use. Keeping the cleaner permanently in the pool may
result in additional service requirements.
POWER SUPPLY OPERATING INSTRUCTIONS
When the power supply is initially switched ON the BOTTOM ONLY CYCLE will
be automatically selected. This is indicated by the light on the cycle selection
switch. The cleaner will automatically shut-off after 2 hours of operation on this
cycle.
To select the full clean cycle depress the FULL CYCLE button at any time during
the cleaning operation. If the BOTTOM ONLY CYCLE has completed simply turn
the power off and back on, then depress the FULL CYCLE button. The light on
the cycle selection switch will indicate that the full cycle has been selected. The
cleaner will automatically shut-off after 4-hours of operation on this cycle.
Nota: to exit the Bottom & Wall Mode and go to Bottom Only Mode, turn the
Power Supply Off and On. The bottom only cycle will be automatically selected.
This is indicated by the light on the cycle selection switch.
Hayward only guarantees the quality, performance and safety of its products when assembled with genuine Hayward manufactured parts.
Page 6 of 19
Use of non genuine Hayward manufactured parts will void all warranty.
SharkVAC XL™ Pilot / e.VAC PRO²™ Robotic cleaner Rev. B