General Information; Prior To Use - Tylo SENSE PURE Série Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15

GENERAL INFORMATION

Congratulations on your new sauna heater! Follow this user guide
to get the most from your purchase.
Wet and dry saunas are forms of bathing which originate way
back in history. A hot sauna is best enjoyed at temperatures
between 70-90°C.

PRIOR TO USE

The fi rst time you use the heater
Fill the stone compartment
NB: Always use dolerite stones (Tylö Sauna Stones)!
"Ordinary" stones may damage the heater.
Do not use ceramic stones. Ceramic stones may
damage the heater. The heater guarantee does not
cover damage caused by ceramic stones.
Fill the stone compartment around the heating elements from the
bottom to the top, to approx. 50 mm above the top front edge.
Do not press the stones into place. Capacity: Approx. 20 kg of
stones.
Place the stones loosely to allow optimum air circulation. The tu-
bular heating elements must not be squeezed together or against
the side.
Sauna stones must:
tolerate extreme heat and fl uctuations caused by water being
poured on them.
be cleaned before use.
must have an uneven surface, so that the water "clings" to
the stone surface and evaporates effi ciently.
be between 30-60 mm in size to allow air circulation in the
stone compartment. This will increase the life of the tubular
elements.
NB: Never place stones on top of the side air
chambers. This way will obstruct air circulation,
causing the unit to overheat and the cut-out switch
to activate.
2
Figure 1: Filling the stone compartment
1.
Stone compartment
2.
Side chambers
Switch on the heater to remove any new paint odours
To remove "new paint odor" from the heater:
Heat the sauna up to approximately 90°C for about one hour.
A little smoke may appear.
Prior to each use
Check the following
Check that:
there are no foreign objects in the sauna cabin, on or in the
heater.
the door and any windows to the sauna cabin are closed.
that the sauna door opens outwards with a little pressure.
NB:
Turn on the main power switch
The main power switch is at the bottom of the heater.
Switch it on, if it is not already switched on (see Figure 2).
1
Figure 2: Positioning of the main power switch
1.
Main power switch
The sauna room or cabin is to be inspected before
either restarting the timer or by switching on the app-
liance by a separate remote-control system
The sauna room or cabin is to be inspected before
setting the appliance to a standby mode for a delayed
start
The door of the sauna room or cabin is fi tted with an
interlock such that the stand-by mode setting for re-
mote operation is disabled if the sauna door or cabin
door is opened when the stand-by mode setting for
remote operation is set
DANGER! Anyone with a mental or physical disabi-
lity or little experience or knowledge of how to use
the equipment (e.g. children) must be instructed or
supervised by someone responsible for their safety.
DANGER! Touching the upper parts of the heater
may cause burn injuries. Tylö recommends
always using the heater screen.
DANGER! Never allow children to play near the
heater!
DANGER! Saunas are not recommended for pe-
ople in poor health. Please consult a doctor.
DANGER! Fragrant essences and similar pro-
ducts may ignite, if poured directly onto the
stones.
DANGER! Covering the heater may cause a fi re.
NOTE! Do not use the sauna cabin for any purpose
other than taking saunas.
WARNING!
5
1

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sense pure 6

Table des Matières