Airplane Mode; Stopping The Device; Standby Mode - Velleman PAMSB10 Mode D'emploi

11. Notification of Incoming Calls
You can let the device notify you when you have an incoming call on your iPhone.
The device will beep and blink to alert you of an incoming call.
1. In the MainView list of available devices, tap the
SetView screen.
2. Set "Call Alert" to ON.

12. Airplane Mode

There are two ways to set the device in Airplane Mode:
First, you switch on the general Airplane Mode of your iPhone/iPad, then you
disconnect the iReminder.
First, you set the iReminder in sleep mode, then you switch on the general
Airplane Mode of your iPhone/iPad.
12.1 After Airplane Mode Is Switched On
When you switch on the Airplane Mode of your iPhone/iPad, its Bluetooth
connection is disabled. As a consequence, the iReminder beeps because it has lost
the link with the iPhone/iPad. Proceed as follows:
1. On the iReminder, press the FindMe button [2] to stop the alarm sound.
2. On the iPhone/iPad, go to the HiProx Multi app and tap Help > AirplaneMode >
YES to disconnect all the paired iReminder devices and exit the app.
3. To quit airplane mode and return to the normal working mode: first switch off
Airplane Mode in the general Settings screen on your iPhone/iPad. This enables
the Bluetooth connection (if not, switch it back on manually).
4. Next, go to the HiProx Multi app and tap Help > AirplaneMode > RECONNECT
to reconnect to all the paired iReminder devices and exit the app.
12.2 Before Airplane Mode Is Switched On
1. On the iReminder, press and hold the FindMe button [2] during ± 3 seconds.
The device beeps once and the status LED blinks once (red), indicating that the
device is now in sleep mode.
2. On the iPhone/iPad, go to the HiProx Multi app and tap Help > AirplaneMode >
YES to disconnect all the paired iReminder devices and exit the app.
3. Go to the general Settings screen of your iPhone/iPad and enable Airplane
Mode.
4. To quit airplane mode and return to the normal working mode: first switch off
Airplane Mode in the general Settings screen on your iPhone/iPad. This enables
the Bluetooth connection (if not, switch it back on manually).
5. On the iReminder, press the FindMe button [2] once to exit sleep mode.
6. Next, go to the HiProx Multi app and tap Help > AirplaneMode > RECONNECT
to reconnect to all the paired iReminder devices and exit the app.
Note: Reconnecting to devices in sleep mode may take up to 20 seconds.
If reconnecting fails, repeat the AirplaneMode disconnect/reconnect steps.

13. Stopping the Device

13.1 Stand-By Mode
To disconnect and go to stand-by mode, proceed as follows:
1. On the iPhone/iPad, go to the HiProx Multi app and tap Help > AirplaneMode >
YES to disconnect all the paired iReminder devices and exit the app.
V. 01 – 02/09/2013
PAMSB10
8
button to enter the the
©Velleman nv