Cleaning And Maintenance - Nordic Home Culture HTR-513 Manuel D'utilisation

Setting the temperature
Press the "+" or "-" button.
The temperature digit will flash.
Continue to press the "+" or "-" button to set the desired
temperature ( temperature range: 5 - 35 ℃). After about 5
seconds with no action, the display will change to show the
current temperature.
The desired temperature is now set.
NOTE: If the current temperature is higher than the set
temperature, the heater will not activate.
Timer setting
A: Setting the timer in order to turn the heater on automatically.
In order to set this function, the heater must be turned off.
Press the timer button.
"0" will flash on the display. Press "+" or "-" button to set the
desired time (0-24 hrs).
B: Setting the timer in order to automatically turn off.
In order to set this function, heater must be on. Press the timer
button.
"0" will flash on the display. Press "+" or "-"button to set the
desired time (0-24 hrs). After the time is set, the room
temperature will show on the display.
C: Cancelling or changing a timer setting.
When the timer indicator is illuminated.
Press the timer button.
Change the hours to "0" to cancel. Or to a different value to
change the timer.
Wait 5 seconds.
Timer setting is now changed.
Select heat setting
There are two heat settings on this heater( the default setting
is High), press the "M" button to select heating setting:1500w
(HI), 750w (LO).
Safety protections
1. Overheat protection: When the temperature in the heater is
too high, the thermostat automatically cuts off the power.
After heater has cooled down, the heater can return to the
normal use.
2. Tip-over protection: When the device tips over or is lifted
and tilted, it will automatically cut off the power.
When it is placed upright it will return to the previous worked
state.
If overheating or malfunctions occurs on regular basis, return
the heater to an authorized service depot for examination.
3. This heater is equipped with a pilot light that glows
whenever the heater is plugged in and turned on.
This feature is intended to help you be aware that heater is still
operating and maintaining the temperature of the room.
User Manual

Cleaning and maintenance

1. The heater should be cleaned regularly to remove dust on
the surface of the flanges. Because this can affect the
efficiency.
2. Unplug from the wall outlet and allow the heater to cool
down, wipe the dust with a soft damp cloth. Do not use
detergents or abrasives.
3. Do not scratch the surfaces of the flanges with sharp hard
tools, to avoid rust.
4. No other user maintenance is required or recommended. If
service is required, send your heater to the nearest authorized
service depot.
5. Store heater in a clean and dry place when not in use.
REMEMBER - portable electric heaters are designed for spot
heating, or as a supplementary heat source. They are not
intended to be main sources of heat during the normal heating
season.
Remote control buttons
= Display and function ON/OFF.
= Increase the temperature and timer setting.
= Decrease the temperature and timer setting.
= Heating mode: High/Low (Same as "M" button on
the heater).
= Timer setting.
Remote control usage
The remote control's functions is the same as on the buttons of
the heater, it allows you to operate the heater even more
easily.
Usage: Point/aim the remote control towards the receiving
window (the black LCD screen) on the heater. And press a
button for response.
Effective distance is about 6 meters.
If the heater is not responding when you are using the remote
control you can try to replace the batteries.
Replacing the batteries
Open the cover of the remote control to remove the old
batteries and replace them with new ones of the same battery
type.
Observe the correct polarity when installing batteries (Plus
(+) and minus (–) terminals aligned correctly).
Do not mix old and new batteries.
ENG
7