Plug the mains plug
a properly installed socket.
Your lamp is now ready for use.
Adjusting the lamp
Note: Only change the alignment
of the lamp when it is switched off.
You can adjust the LED table lamp
to the lighting conditions you re-
quire. To do so, use the 3 joints:
1. Swivel joint with lamp base
: the lamp arm
7
turned approx. 35° in both
directions from the midpoint.
2. Lower tilt joint: with this you
can move the lamp arm
forwards or backwards.
3. Upper tilt joint: with this you
can move the lamp head
upwards or downwards.
into
9
You can set the colour of the light
can be
in 3 stages from warm-white
2
3000 K to cold-white 6500 K.
2
1
The light has 6 dimmer settings.
To dim the light, simply touch the
Dim
Switching the
lamp on / off
Switch the lamp on or off
using the ON / OFF switch
on the lamp base
All you need to do here is
press it with your finger
(touch button).
Selecting the
light colour
Touch the light colour selec-
tion button
for this. When
4
you switch the lamp on, it will
automatically be set to the
last light colour to have been
used.
Dimming
button on the base
5
3
.
7
.
7
GB/IE
21