Remote Control - IN & OUT HOUSE EF197A Instructions D'utilisation

E N
2. M A N UA L CONTROL PA NEL
F L A M E P I C T U R E
H E AT I N G I N D I C AT O R
R E S E T
B A S E T R AY L E D L I G H T
B U T T O N
L I G H T O N / O F F
N OT E: The manual buttons control basic functions, but not all operating
controls. To perform all functions, use the remote control.
• The manual buttons are located at the bottom right of the unit.
• Press "LIGHTS ON / OFF" to switch both the flame light and the mood light
on or off at the same time.
• Press the "FL AME" button to select the colour of the flame (three types)
or to return to the OFF position.
• Press the "MOOD LIGHT" button to select the colour of the mood light
(13 types), the colour cycle mode or the return to the OFF position.
• Press the "FUEL BED" key to select the LED light in the base tray (13 types),
the colour cycle mode or the return to the OFF position.
34
M A I N S W I T C H O N / O F F
M O O D L I G H T
E N
N OT E: The remote control of the unit loses the memor y for all function
settings when the switch is set to OFF. If the remote control is empty
or if you change the batteries, only the flame function loses its memor y
and the timer settings are not affected. However, the clock may need
to be adjusted.
3. R EMOTE CONTROL
T E M P E R AT U R E S E N S O R
D I S P L AY
M O D E P O W E R
H E AT I N G /
F L A M E E F F E C T
P R O G R E S S
L E D L I G H T
M O O D L I G H T
B A S E T R AY
T I M E R
T I M E A N D W E E K
T E M P E R AT U R E
N OT E: This is a thermostatic remote control. The remote control should
be in the same room as the fireplace and lie on a flat surface. The
remote control must be placed away from the fireplace so that hot air
does not affect the thermostatic reading.
P R O G R E S S
T I M E R
B AT T E R Y
16:58 M on
P O W E R
R O O M
S E T
T E M P E R AT U R E
H E AT I N G P E R I O D
35