Securing The Heat Pump To The Roof - Airxcel 47000 Série Instructions D'installation

A mounting frame is supplied with the ceiling assembly.
Follow the steps below to secure the heat pump to the roof.
Refer to Figure 4.
A. Locate the heat pump mount gasket over the 14" to
15" square opening in the roof.
B. Install the ceiling assembly mount frame using the
four bolts found with the ceiling assembly.
V. SECURING THE HEAT PUMP TO THE ROOF
FIGURE 2
FIGURE 4
FIGURE 3
C. Proper tension has been achieved for each bolt when
any portion of each gasket indicating tab has been
pulled down even with the roof. See Figure 4. The
upper unit has now been properly installed with
optimum gasket compression.
D. If the heat pump is equipped with an optional
evaporator condensate pump, a 1/2" I.D. hose must
be provided that runs from the 14" square opening,
through the vehicle ceiling and down the side wall to
allow water to drain under the vehicle. The hose
must not be allowed to kink shut while making a
bend. Connect the top end of the drain hose to the
barbed fitting shown in Figure 4.
5
Height Varies To
Make Unit Level