Table Des Matières; General Information - Airxcel 47000 Série Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

I.
General Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
II.
Heat Pump Sizing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
III.
Selecting an Installation Location . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
IV.
Installing the Roof Top Unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
V.
Securing the Heat Pump to the Roof . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
VI.
Electrical Wiring . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
VII.
Installing the Ceiling Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
VIII. Completing the Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
These instructions are a general guide for installing the 47000 series Coleman-Mach roof top heat pump. For specific heat pump
details, it will be necessary to refer to the printed Customer Envelope Package supplied with each heat pump.
IMPORTANT NOTICE
These instructions are for the use of qualified individuals
specially trained and experienced in installation of this type
equipment and related system components.
Installation and service personnel are required by some states
to be licensed. PERSONS NOT QUALIFIED SHALL NOT
INSTALL NOR SERVICE THIS EQUIPMENT.
The words "Shall" or "Must" indicate a
requirement which is essential to
satisfactory and safe product performance.
The words "Should" or "May" indicate a
recommendation or advice which is not
essential and not required but which may
be useful or helpful.
OEM - Please make sure the Customer Envelope Package
accompanies the heat pump.
INSTALLER AND/OR DEALER - Please make sure the
Customer Envelope Package is presented to the product
consumer. The product consumer should also be afforded the
opportunity to purchase the optional three (3) year parts
replacement contract available from Airxcel.
For more information about the contract, please review the
sample contract located in the Operation and Maintenance
Instructions Booklet (Customer Envelope Package). Use the
card attached to the Customer Envelope Package to apply for
the extended parts contract.
TABLE OF CONTENTS
NOTE

1. GENERAL INFORMATION

WARNING - SHOCK HAZARD
To prevent the possibility of severe personal injury or
equipment damage due to electrical shock, always be sure
the electrical power source to the appliance is
disconnected.
CAREFULLY FOLLOW ALL INSTRUCTIONS AND
WARNINGS IN THIS BOOKLET TO AVOID DAMAGE
TO THE EQUIPMENT, PERSONAL INJURY OR FIRE.
Improper installation may damage equipment, can create
a hazard and will void the warranty.
The use of components not tested in accordance with these
units will void the warranty, may make the equipment in
violation of state codes, may create a hazard and may ruin
the equipment.
INQUIRIES ABOUT THE HEAT PUMP UNIT - Inquiries to
your Airxcel representative or to Airxcel pertaining to product
installation should contain both the model and serial numbers
of the roof top heat pump. All roof top heat pump units have
model and serial number identification in two locations:
(1) rating plate sticker which is assembled to the evaporator
cover of the roof top heat pump unit (necessitates removal of
shroud for viewing), (2) model/serial number sticker (silver
color) located on the bottom of the basepan of the roof top
heat pump. If the heat pump is installed, the sticker may be
viewed by lowering the ceiling assembly shroud.
2
2
3
3
3
5
6
7
9
WARNING

Publicité

Chapitres

Table des Matières
loading

Table des Matières