Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8
Installing batteries
CAUTION
Failure to use batteries according to instructions can be hazardous.
•
Always use Alkaline batteries of the same type.
•
Ensure that batteries are installed with correct polarity. Damage to the batteries and
the equipment can result from installation with incorrect polarity.
•
Never toss batteries into a fire, due to the risk of explosion.
•
Never allow battery terminals to come into contact with each other or with metal
objects, either intentionally or accidentally. This can cause overheating, fire or
explosion.
•
Keep batteries out of the reach of children. Consult a doctor immediately in case of
swallowing.
•
Fluid from leaking batteries can cause permanent damage to the equipment. Take
particular care when handling damaged or leaking batteries, due to the risk of
corrosion. Wear safety gloves.
•
Remove the batteries if the equipment will not be used for an extended period.
•
Open the battery compartment by pulling the cover away on the
bottom of the unit.
•
Insert 4 AAA/LR03 Alkaline batteries. Follow the polarity as indicated
in the battery compartment.
When the batteries are low,
batteries must be replaced.
9
Setting date, time and measurement unit
•
When the monitor is off, hold pressing "S" button for 3 seconds to enter the mode for year setting.
Or when the monitor is off, press "S" button shortly, it will display the time. Then hold pressing "S"
button to enter the mode for year setting.
•
Press "M" button to change the [YEAR]. Each press will increase the numeral by one in a cycling
manner.
•
When you get the right year, press "S" button to set down and turn to next step.
•
Repeat steps 2 and 3 to set the [MONTH] and [DAY].
•
Repeat steps 2 and 3 to set the [HOUR] and [MINUTE].
•
Repeat steps 2 and 3 to set the [UNIT] (kPa or mmHg).
•
After the unit is set, the LCD will display "done" first, then display all the settings you have done
and then turn off.
10
Select the user
•
When the monitor is off, press "S" button to enter the selecting user mode, then press "S" button
again to select the user between User 1 and User 2.
•
If the LCD displays your desired user, press "START/STOP" button to turn off the device, the
User selection is finished. Then press "START/STOP" button, you can start your measurement.
21
is displayed. Low
BD-4603 ALB/ALS
Publicité
Table des Matières
