Charging The Battery Pack - Oregon BL300 Manuel D'instructions

CHARGING THE BATTERY PACK

WARNING: Failure to follow proper
charging procedures may cause excessive
voltage, excessive current flow, loss
of control during charging, leakage of
hazardous chemicals, heat generation,
bursting, or fire. Follow these charging
instructions.
With the charger cord connected to the charger
and plugged into an electrical outlet, align the
grooves in the battery with the rails on the
charger and slide the battery pack onto the
charger until fully seated (Fig 8)
FIG. 8
Check the charge-state indicator for charging
conditions
16
Operating the Blower
INSERTING AND RELEASING
THE BATTERY PACK
Only use the Oregon® brand battery packs
specified in these operating instructions
Align the groove in the battery with the rails
inside the battery port Firmly insert the
battery pack into the blower's battery port,
pressing forward until it clicks as it locks into
place (Fig 9)
FIG. 9
To remove the battery pack, lift up on the
battery release, grasp the sides of the battery
pack and remove it (Fig 10)
FIG. 10
Blower Model BL300