Operating The Blower; Battery Pack And Charger - Oregon BL300 Manuel D'instructions

Operating the Blower

Battery Pack and Charger

WARNING: To reduce the risk of shock,
do not charge the battery pack in the rain.
BATTERY PACK LED CHARGE-
LEVEL INDICATOR
The lithium ion battery pack is equipped with an
LED charge-level indicator To test the charge
level of the battery pack, press the indicator
button on the battery pack's face (Fig 5)
No lights: recharge
One steady green light:
less than 25% charged
Charge battery pack before use
Two steady green lights:
26–50% charged
Three steady green lights:
51–75% charged
Four steady green lights:
76–100% charged
FIG. 5
INDICATOR BUTTON
INDICATOR LIGHTS
CONNECTING THE CHARGER
If the charger includes a separate power cord,
connect the charger cord to the charger and to
the proper electrical outlet (Fig 6)
FIG. 6
Blower Model BL300
Operating the Blower
Only use the cord set that was supplied with
the charger At first use, verify that the plug
type matches the receptacle
CHARGER LED CHARGE-STATE INDICATOR
The battery charger is equipped with an LED
charge-state indicator that indicates the state
of charging as well as conditions that may
delay or prevent charging (Fig 7)
Note: Until a battery pack is inserted, no lights
will be visible
Blinking orange light: a fault condition
exists There are several potential
causes See "Troubleshooting" in this
manual
Steady orange light: the battery pack
temperature is beyond the acceptable
range (32°F/0°C to 104°F/40°C) Allow
the battery pack to reach the
acceptable temperature range before
charging The pack may be left on the
charger as the temperature adjusts
Charging will begin when the proper
temperature is reached
FIG. 7
Blinking green light: battery pack is
charging
Steady green light: battery pack is
ready for use
15