Sony NSR-500 Série Manuel D'installation page 16

F
LAN connectors (1 and 2)
Use these connectors to connect
10Base-T, 100Base- TX, or 1000Base-
T network cables.
LAN1: Network cameras
LAN2: Network cameras
only be used when using a different
segment from LAN1.)
1) Connect remote clients to the network
specified with the [Network Interface for
Remote Client] setting (either LAN1 or
LAN2) in the Server Configuration
screen. For details, refer to the User's
Guide (PDF).
Caution
• Do not configure LAN connectors 1
and 2 to the same network segment.
• For details on using iSCSI storage,
contact your Sony dealer.
CAUTION
• For safety, do not connect the
connector for peripheral device
wiring that might have excessive
voltage to the following ports.
- LAN1 connector
- LAN2 connector
Follow the instructions for the above
ports.
• When you connect the LAN cable of
the unit to peripheral device, use a
shielded-type cable to prevent
malfunction due to radiation noise.
G
Monitor connectors (1 and 2)
Use this connector to connect a monitor
that supports analog RGB input.
Caution
If the optional NSBK-DH05 is installed,
monitor connector 1 will not be
available for use. Only monitor
connector 2 will be available. Monitor
connector 2 and the HDMI monitor
16 Features and Functions
H
1)
1)
(LAN2 can
I RS-422/485 connector
J ALARM OUT (alarm output)
K SENSOR (sensor input) connector
L Power supply connector
M HDMI monitor connector
connector cannot be used at the same
time.
USB connectors (1 and 2)
Use this connector to connect a USB
mouse, keyboard, USB flash memory,
or system controller (RM-NS1000) to
the unit.
Use this connector to connect analog
cameras via the analog camera input
cable.
This connector cannot be used at the
same time as the E RS-232C 2
connector.
For pin assignment details and wiring
diagrams for sensor inputs, see "I/O
Port" (page 41).
connector
Use this connector to connect the alarm
output lines.
For connection details and a wiring
diagram for alarm output, see"I/O
Port" (page 41).
Use this connector to connect the sensor
input lines.
For connection details and wiring
diagrams for sensor inputs, see "I/O
Port" (page 41).
Use this connector to connect the power
cord.
Use this connector to connect a monitor
that supports HDMI input.
Monitor connector 2 and the HDMI
monitor connector cannot be used at the
same time.