Renkforce RF FTVK-100 Notice D'emploi page 23

Pairing
The headphones and charging/transmission station are supplied paired. Following a loss of connection of under other
circumstances, pairing may be lost. In that case, a wireless connection cannot be established and the pairing process
must be repeated.
• If no wireless connection can be established between the headphones and charging/transmission station, the PAIR
indicator (10) lights up.
• In that case, press the SCAN button (1) on the charging/transmission station and the CH button (18) on the head-
phones for three seconds simultaneously.
• The AUX/MIC IN indicator (8) on the charging/transmission station and PAIR indicator (10) on the headphones flash
during the pairing process.
• Once the connection has been established, both indicators light up continuously.
Carry out pairing only if you cannot establish a wireless connection.
Function of indicators and controls on the headphones and charging/transmission station
Indicators and controls
SCAN button (1)
ON/OFF switch (5)
POWER/CHARGE indicator (7)
AUX/MIC IN indicator (8)
STANDBY indicator (9)
PAIR indicator (10)
VOL control (11)
ON/OFF switch (12)
TONE control (13)
BALANCE control (14)
CH button (18)
The charging/transmission station switches the wireless connection off automatically after a short time if no
audio signal is available. If a new audio signal is detected, the charging/transmission station transmits it.
If no wireless signals is being received, the headphones switch to standby mode after a short time. The
headphones switch on automatically when a wireless signal is detected.
Function
Press for 3 seconds to start pairing
Switches the charging/transmission station on or off
Green >> Charging/transmission station is switched on
Yellow >> Battery in headphones is being charged.
Green >> Audio signal available at AUDIO IN (3) or MIC IN (2)
Flashing green >> Pairing
Yellow >> No audio signal available
Continuous red >> Headphones in standby mode
Flashing red >> Wireless signal lost (e.g. range exceeded)
Blue >> Wireless signal was detected
Flashing blue >> Pairing
Does not light up >> No wireless signal detected
Controls the volume of the headphones
Switches the headphones on or off
Controls the tone of the headphones
Adjusts the volume of the right-hand and left-hand side of the headphones
Press for 3 seconds to start pairing
23