Inserting And Charging The Battery; Audio Connection - Renkforce Rf Ftvk-100 Notice D'emploi

b) Inserting and charging the battery
• Slide the ON/OFF switch (12) on the headphones to the OFF position.
The headphones must be switched off when inserting and charging the battery.
• Open the battery compartment (16) on the headphones and insert the battery.
If the contacts of the battery have a protective film, remove the film before insertion.
Pay attention to the position of the contacts. The battery must be inserted so that the contacts in the battery
compartment (16) are opposite the contacts on the battery.
• Close the battery compartment (13) again.
• To charge the battery, insert the headphones into the charging tray (6) of the charging/transmission station.
• The POWER/CHARGE indicator (7) lights up yellow to indicate charging.
• When the battery is fully charged, the POWER/CHARGE indicator (7) lights up green.
The headphones can only be inserted into the charging/transmission station in the correct direction.
Before operation, the battery must first be charged for approx. 12 hours. After the first charge, charging
usually takes approx. 1.5 - 2 hours.
The operating time with a fully charged battery is approx. 9 hours at medium volume.
c) Audio connection
The charging/transmission station and the headphones are only suitable for connection to low-level audio
signals. Connect them only to devices with these types of connection (headphone connections, phono
connections, etc.).
If in doubt, consult an expert.
Non-observance of these notes can cause damage to the wireless TV headphones or to connected
devices.
• Connect the AUDIO IN (3) connection on the charging/transmission station to the headphone connection of your
TV device using the enclosed audio cable.
If your TV device has a phono connection, you can use the enclosed adapter cable.
Use as wired headphones
The headphones can also be used as wired headphones without wireless connection between the charging/transmis-
sion station and headphones.
• To do this, connect the LINE IN connection (15) on the headphones directly to the headphone connection of your
TV device using the enclosed audio cable.
If the headphones are used as wired headphones, the indicators on the headphones switch on automati-
cally. The headphones must also be switched on in this operating mode.
21