Cleaning The Device; Storing The Device - mebby NO TOUCH Mode D'emploi

• Take the used batteries out of the battery compartment.
• Insert new batteries.
Make sure that the batteries are inserted the right way round.
• Close the battery compartment.
The empty, completely flat batteries must be disposed of through specially designated col-
lection boxes, recycling points or electronics retailers. You are legally required to dispose of
the batteries.
The codes below are printed on batteries containing harmful substances:
PB = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.

10. Cleaning the device

• The measuring sensor is the most sensitive part of the thermometer. Take great
care of the measuring sensor when cleaning the device.
• Do not use any harsh cleaning products.
• Always observe all safety notes for user and device.
Safety notes w Page 21.
Clean the measuring sensor after each use. Use a clean cloth or cotton bud that can be
moistened with disinfectant or 70 % alcohol.
To clean the entire device, please use a soft cloth slightly moistened with a mild soapy solu-
tion. Under no circumstances may liquid enter the device.
Do not use the device again until it is completely dry.
11.

Storing the device

The device must not be stored or used at an excessively high or low temperature or humid-
ity (see technical specifications), in sunlight, in association with an electrical current or in
dusty locations. Otherwise inaccuracies can occur.
If prolonged storage is planned, you should remove the batteries.
100022_MEBBY NO TOUCH USER MANUAL_REV.00_21.04.2016.indd 53
53
14/06/2016 11:32:59