Electromagnetic Compatibility Information - mebby NO TOUCH Mode D'emploi

Electromagnetic Compatibility Information

Table 1
For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer's declaration – electromagnetic emissions
The No Touch is intended for use in the electromagnetic environment specified below.
The customer or the user of the No Touch should assure that it is used in such an environment.
Emissions test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations/flicker emissions
IEC 61000-3-3
130
100022_MEBBY NO TOUCH USER MANUAL_REV.00_21.04.2016.indd 130
Compliance Electromagnetic environment – guidance
Group 1 The No Touch uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
Class B The No Touch is suitable for use in all establishments, inclu-
ding domestic establishments and those directly connected
Not applicable
to the public low-voltage power supply network that sup-
plies buildings used for domestic purposes.
Not applicable
14/06/2016 11:33:06