Displaying Saved Measurements - mebby NO TOUCH Mode D'emploi

GB Non-contact fever thermometer Mebby NO TOUCH
Hold the thermometer 2 to 3 cm from the measuring point. Press the
SCAN button and move the thermometer from side to side over the
forehead area (fig. 8).
During measurement you will hear short beeps (only if the acoustic signal is activated), which
signal that the thermometer has found a new highest measurement.
End of measurement is signalled by a long beep.
Release the SCAN button.
You can now read the measured value.
In addition to the temperature, the fever
The no fever symbol
fever symbol indicates a measurement equal to or higher than 38°C (100.4°F), which
triggers a temperature alarm.
If the acoustic signal is switched on, three beeps will sound once the measurement is com-
plete if the temperature is equal to or higher than 38°C (100.4 °F).
The measuring time is usually 2 seconds but may take up to 30 seconds.
When two short beeps sound and the forehead symbol
ment.
The measurement is automatically saved with the date/time and the "fever"

6.1 Displaying saved measurements

The device only stores measurements in forehead temperature mode
matically stores the values from the last 60 measurements.
When 60 storage places are exceeded the oldest value is deleted.
The memory can be called up as follows:
• With the thermometer switched on, press and hold the MODE/MEM button for 5 seconds.
The most recent measurement is displayed.
• With each subsequent pressing of the MODE/MEM button, first the storage space number is displayed followed
by the measurement upon release.
• In the upper line, the time and date are displayed alternately.
50
100022_MEBBY NO TOUCH USER MANUAL_REV.00_21.04.2016.indd 50
or no fever symbols also appear in the display:
indicates that the body temperature is within normal range; the
stops flashing, the device is ready to take another measure-
Fig. 8
/ "no fever" classification.
. The device auto-
14/06/2016 11:32:59