Switching Signal Tones On And Off; Button Functions Of Wireless Operating Panel On The Wireless Alarm System - ABUS Security-Center FU5165 Instructions D'installation

If you train a new secvest. 868 wireless alarm system for the wireless
key switch, previously learned data is automatically deleted in the
wireless alarm system.

8.4. Switching signal tones on and off

Press the program button (15) four times to enter this mode. The display
shows . Keep the button pressed until the
During programming, the switching on and off of the signal tones is shown
by and after about 1 second, the current programming is displayed (e.g.
). You can now change this number by pressing the button several times.
The signal tones are activated if a
deactivation of the signal tones on the wireless key switch.
When the desired value is reached, press the button and keep it pressed
until appears on the display.
8.5. Button functions of wireless operating panel on the
wireless alarm system
The buttons of a wireless operating panel of the secvest. 868 wireless
alarm system have the following functions as a default:
Button 1 Activate all
Button 4 Deactivate all
The right button (12) of the wireless key switch is used for arming
(condition at delivery). This button corresponds to button 1 in the secvest.
868. installer menu
The left button (11) of the wireless key switch is used for disarming
(condition at delivery). This button corresponds to button 4 in the secvest.
868. installer menu
To arm/disarm the secvest. 868 wireless alarm system, you don't need to
make any changes under this menu item of the wireless alarm system.
To internally arm a partition with the wireless key switch or switch outputs,
go to the installer menu of the wireless alarm system and select "Other
devices Arming station
is displayed. A
Other devices
Other devices
Edit arming station" and select the
27
appears on the display.
Arming station.
Arming station.
shows the