Recording - Sharp GX-CD1200W Mode D'emploi

RECORDING

When recording important selections, be sure to make a
preliminary test to ensure that the desired material is being
properly recorded.
The VOLUME, X-BASS, SURROUND and GRAPHIC
EQUALIZER controls may be adjusted with no effect to the
recorded signal (Variable Sound Monitor).
Built-in microphone
BEAT CANCEL
A B C
Recording from the CD player
1
Set the FUNCTION switch to CD.
Load the disc to be recorded.
2
Load a cassette into the TAPE 1 cassette compartment.
3
Press the RECORD button.
4
Press the PLAY/PAUSE button on the CD.
To stop recording:
Press the STOP/EJECT button.
The tape will stop.
Note:
If the STOP or PLAY/PAUSE button on the CD player is
pressed whilst recording, or if the CD comes to its end, the
tape deck will not stop.
To record a specific track:
Press the UP or DOWN button on the CD player until the de-
sired track number is displayed, then start recording.
Recording from the radio
1
Tune in to the desired station. (See page 7.)
2
Load a cassette into the TAPE 1 cassette compartment.
3
Press the PAUSE button of TAPE 1.
4
Press the RECORD button of TAPE 1, which also engages
the PLAY button.
Metal and CrO
RECORD
PLAY PAUSE PLAY
5
Press the PAUSE button of TAPE 1 again to begin record-
ing.
Beat cancel switch:
If a whistling noise occurs when recording from an MW, SW1
or SW2 station, set the BEAT CANCEL switch to A, B or C,
whichever gives the best reception.
Recording from the microphone
1
Set the FUNCTION switch to TAPE.
2
Set the DUBBING SPEED switch to MIC.
3
Load a cassette into the TAPE 1 cassette compartment.
4
Press the PAUSE button of TAPE 1.
5
Press the RECORD button of TAPE 1, which also engages
the PLAY button.
6
Press the PAUSE button again to begin recording.
Notes:
Do not connect anything to the MIX MIC socket.
Monitoring of the recording is not possible.
Recording from the built-in microphone is not in stereo.
E-9
tapes cannot be used for recording.
2
PLAY/PAUSE
FINE TUNING
TUNING
FUNCTION
TAPE 1
DIRECTION