Bartscher 347107 Manuel D'installation page 8


Improper use of the appliance;

Exceptional and unforeseeable events;

Unrespect to domestic legislation on health, hygiene and safety at the workplace;

The employer is responsible for the periodic training of the operators about the correct use, safety rules and fire prevention.
2. TECHNICAL DATA
RANGE OF HEATED CUPBOARDS
Supply voltage
Frequency
Max. power input
Max. current requirement
Power cord
Max. supply Voltage variation
Max. Frequency variation
Max. Frequency variation
WARNING!
3. INSTALLATION AND COMMISSIONING
WARNING!
Proceed according to the following instruction before connecting the appliance:

Remove the packaging and then the protective film taking care not to scratch the surface;

Arrange the appliance and adjust its height and level by means of the adjustable feet;

Make sure the power supply of the appliance shown on the data plate is compatible with the grid voltage;

Check the power supply of the system is set up and able to take the current load, and meets the legal requirements and domestic standards;

The appliance must be earthed;

In case of direct connection to the electricity grid (without plug), it's necessary providing for a wall switch or a contactor, which grant the complete
disconnection according to overvoltage III rate and accordingly to installation rules;

Have the system tested by a qualified electrician, if operation of the equipotential earth connection or the safety of the electrical system is in doubt, the
symbol below identifies the equipotential connection:
The Manufacturer declines all responsibilities in case of connection made by the user or unspecialized staff
WARNING!
This appliance is designed and optimized to ensure high performance and efficiency. The sole use of this appliance is to store and heat tableware. Any other use
is not permitted (e.g. heating food).
V
Hz
W
A
Mmq-H05RN-F
continuous
Short period

The electric power system and the rooms where the appliance is placed have to respect
domestic legislation on safety, accident prevention and fire regulations. On the contrary
the Manufacturer won't assume liability for direct and indirect damages to people or
things.

Intervention on the electric power system must be solely performed by specialized
electricians.

After installation dispose of the packaging according to current regulations.
220-240
50-60
2000
10
3x1,5
+/- 10%
+/-1%
+/- 2%
8