Racer INVERTER 7 Notice D'installation Et D'utilisation page 92

7) Set the desired temperature
You can set the target water temperature by adjusting the slider or press " " or " ".
The setting water temperature on the controller display correspondingly changes after letting go. When the
setting water temperature on the display changes, it will be synchronously updated to the APP.
8)Check device information.
In the main interface, click the upper right "Alsavo Pro". The Device info will show up.
9)Revise the heat pump info in the homepage
Click " " , you could rename, change its password and delete the device.
In the communication, APP act as a host, while the display as a slave:
1. When the parameters are modified in the APP, accordingly it will be updated in the display.
2. When the parameters changes in the display, also it will be updated in the APP.
- 89 -