Racer INVERTER 7 Notice D'installation Et D'utilisation page 73

d6
d7
d8
d9
d10
d11
Remark: d4: Frequency limitation code,
0: No frequency limit,
1: Coil pipe temperature limit,
2: Overheating or overcooling frequency limit,
4: Drive Current frequency limit,
8: Drive voltage frequency limit,
16: Drive high temperature frequency limit.
Press first, then press
If needed, press
(for example: Press
press or
Code Name
P0 Manual defrost
P1 Working mode
P2 Timer on/off
P3 Water pump
P4 Current time
P5 Timer on
P6 Timer off
Inlet water temp.
P7
correction
NOTE: Under defrosting mode, P0=1.
After defrosting finished, it will be automatic enter Normal mode, P0=0.
7.4.4 System reset function
Press and
7.4.5
Symbol of heating, the light will be on when it is in operation.
When defrosting, the light will flash.
7.4.6
Gas exhaust temperature
Step of EEV
Compressor running frequency
Compressor current
Current fan speed
Error code for last time
to check the User parameter from P0 to P7
second, then press
first, then press
to adjust the parameter P7 Inlet water temp. Correction from -9 to 9.)
Scope Default
0-1 0 1 Manual defrosting mode, 0 Normal mode
0-1 1 1 Heating mode，0 cooling mode
1 Timer on/off is under function ， 0 Timer on/off is out of
0-1 0
function (The setting of P4 and P5 won't work)
0-1 0 1 Always running， 0 Depends on the running of compressor
HH:MM 00：00 0-23:0-59
HH:MM 00：00 0-23:0-59
HH:MM 00：00 0-23:0-59
-9～9 0 Default setting: 0
in 10s, the system will reset and display "0000" on the controller.
0℃～C5℃ (125℃)
0～99
0～99Hz
0～30A
0-1200 （rpm）
All error code
or to adjust the current parameter.
to enter parameter P7 checking, and press
Remark
- 70 -
Real testing value
N*5
Real testing value
Real testing value
Real testing value
second, then