Initial Operation - M-E Easy2wire ADB-1140 Mode D'emploi

easy2wire ADB
| ENGLISH
3. Drill the mounting holes with a 6 mm drill and insert a dowel into
each hole.
4. Push the wires through the corresponding feedhole in the back half
of the casing.
5. Screw the lower half of the casing onto the wall.
6. Connect the wires in accordance with the wiring plan and place the
front half of the casing onto the lower section. Make sure it clicks
correctly into place.
SETTINGS on the INDOOR and OUTDOOR STATIONS
ENCODING (indoor station)
There are DIP switches (B.14) on the indoor station for encoding. Each
indoor station needs to be set to the correct code. If one party has
several indoor stations then the encoding must be the same for all
indoor stations belonging to the party.
One-family version
DIP switch 1 „ON", all others „OFF"
Two-family version
GB
Indoor station(s) for family 1
DIP switch 1 „ON", all others „OFF"
Indoor station(s) for family 2
DIP switch 2 „ON", all others „OFF"
NOTE: If two or more indoor stations are connected then DIP switch 6
must be switched to "ON" on the last indoor station.
CONVERSATION VOLUME (outdoor station)
The conversation volume on the outdoor station is set using the
potentiometer (A.10). For full volume turn the potentiometer carefully in
a clockwise direction to its limit and then turn it back a little. Turn it in
an anti-clockwise direction to reduce the volume.
CONVERSATION VOLUME (indoor station)
You can set the conversation volume on the indoor station in several
stages using the two buttons B.7 and B.8 on the side.
RINGER VOLUME (indoor station)
The ringer volume on the indoor station is set using the potentiometer
(B.9). For full volume turn the potentiometer carefully in a clockwise
direction to its limit and then turn it back a little. Turn it in an anti-
clockwise direction to reduce the volume.
CHANGING THE RING TONE (indoor station)
The ring tone can be changed using button B.6. Press the talk button
(B.4) to activate the indoor station. Then press on the melody button
(B.6) and a melody will play. Keep pressing the melody button until the
desired ring tone plays. To confirm the melody press the talk button. The
set melody is then saved.
If the system is disconnected from the mains the melody will be set back
to the factory setting.
DEACTIVATE RINGER MELODY (e.g. during the night)
It is possible to deactivate the ringer melody, e.g. in order not to be
disturbed at night. To do this, press the mute button (B.1) on the indoor
unit down once, briefly. The LED on the mute button lights up red to
remind you that the melody is deactivated. To re-activate the melody
press the mute button briefly again. The red LED will go out and the
melody is reactivated.
The optical signal (the illuminated frame on the talk and door opener
button) remains active even when the ringer melody is deactivated and
continues to light up when the bell is rung. The red LED also flashes if
the bell is rung while muted.

INITIAL OPERATION

Connect the mains power supply unit to the 230 V network once all the
components are connected and encoded. Then ring the bell once in order
to initialise the system. This initialisation needs to be carried out each
time the system is disconnected from the mains.
OPERATION
1. Press the ringer button.
2. The set melody will sound at the corresponding indoor station(s).
3. Accept the conversation at the indoor station by briefly pressing on
the talk button (MOUTH).
4. If a door opener is connected you can activate the door opener by
pressing briefly on the door opener button (KEY).
5. Press the talk button again briefly (MOUTH) in order to switch the
system back to standby.
12 12