Selecting Your Steam Setting; Using The Steam Energized ™ Cleanser - shark SK460 Série Manuel Du Propriétaire

MOP
SCRUB
fig. 10

Selecting Your Steam Setting

1 Press the Steam Control button once for
SaniFiber disposable pad setting (SaniFiber
™
disposable pad lighted setting indicator will
illuminate). SaniFiber
designed to deliver the perfect amount of steam for
your SaniFiber pads. It can also be used with your
™
washable pad for a quick dusting. (Fig. 10)
Press the Steam Control button a second time
to activate the MOP setting. MOP setting is for
normal, everyday steam cleaning.
Press the Steam Control button a third time to
activate the SCRUB setting. SCRUB setting is for
heavy cleaning and will leave floors damp.
To better understand which steam setting to use for
your cleaning task, turn to page 8.
2 Clean your floors with a forward and backward
motion. (Fig. 11)
3 Press the Steam Control button until the light
flashes to stop the steam.
WARNING: Never stand on the Professional
Steam & Spray Mop.
™
4 When the water tank is empty, the steam mop will
stop producing steam. You can refill the water tank
at any time as long as the mop is unplugged from
the electrical outlet. Follow instructions on page 4.
disposable pad setting is
™
fig. 11
™
Using the Steam Energized
1 Make sure that the batteries are inserted into the
battery compartment behind the reusable bottle.
See page 3.
2 Press the Spray Button to apply solution onto the
floor that is to be cleaned. (Fig. 12, Fig. 13)
3 If the Cleanser Bottle is empty, you can replace it at
any time as long as the unit is unplugged from the
electrical outlet.
IMPORTANT: Never leave the Professional Steam
& Spray Mop with a damp/wet cleaning pad on
™
any floor surface for any amount of time as this
may damage the floor.
4 Once finished, step on the tab at the back of
the cleaning pad and lift the unit to remove the
cleaning pad.
fig. 12
fig. 13
Cleanser
™
www.sharkclean.com
5