Cleaning Your Hard Floors; Spray ™ Mop; Professional Steam & Spray ™ Mop; Filling The Water Tank - shark SK460 Série Manuel Du Propriétaire

Using Your Professional Steam & Spray
IMPORTANT: When cleaning, do not use
the Professional Steam & Spray
attaching a Cleaning Pad, inserting the Steam
Energized Cleanser bottle and filling the water
™
tank first.
fig. 6
fig. 8

Cleaning Your Hard Floors

Filling the Water Tank

1 Turn the water tank cap counter clockwise and
remove from the unit. (Fig. 6)
2 Using the filling flask, pour water into the water
tank. Do not overfill. Replace the cap on the water
tank. (Fig. 7)
NOTE: To prolong the life of your Professional
Steam & Spray Mop, we recommend using
™
distilled water.
3 Insert the Steam Energized
unit upside down. Push it down to make sure that
it is well inserted. You will hear an audible "Click"
when the Cleanser bottle is inserted properly.
(Fig. 8)
NOTE: To remove the Steam Energized
bottle hold it and pull it up. (Fig. 9)
4
1-800-798-7398
Mop without
™
fig. 7
fig. 9
Cleanser bottle into the
™
Cleanser
™
Mop
™
IMPORTANT: When you are using the mop
for the first time, it might take longer than the
normal 30 seconds to start steaming.
IMPORTANT: Do not use on unsealed wood or
unglazed ceramic floors. Do not use on wood or
tile floors that are highly worn, unfinished or have
a wax or oil finish. Surfaces that have been treated
with wax or some no wax floors may be damaged
by the cleaning solutions therefore it is always
recommended to test an isolated area of the surface
to be cleaned before proceeding. You should always
check the use and care instructions from the floor
manufacturer.
IMPORTANT: Make sure the floors are swept or
vacuumed before using the Professional Steam &
Spray Mop.
™
Visit www.sharkclean.com for other great quick
cleaning products to complement your Professional
Mop, such as the Shark
Steam & Spray
™
Rotator
™ vacuums.
4 Twist the quick release cord holder to unwrap the
power cord completely. Plug into an electrical
outlet. Secure the power cord to the upper and
lower cord hooks.
5 Make sure that the Cleaning Pad is attached to the
mop head.
6
The Steam Control button will flash blue. If the light
does not turn on, reference the troubleshooting
section on page 9.
®