Rf Remote Control; Fcc Caution - Zephyr Tornado II AK8200BS Guide D'utilisation, D'entretien Et D'installation

ZEPHYRONLINE.COM

RF Remote Control

FCC Caution

To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example -
use only shielded interface cables when connecting to computer or peripheral device. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1)
This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Synchronization
To create a unique link between your hood and remote control please follow these steps.
1. With hood off, press and hold the "lights" button on the hood until the letter "F" shows on the
display screen.
2. Press on the remote, the lights on the hood will turn on and synchronization is complete.
RF Remote Control Functions
Blower On/
1
2
Speed Selection
Lights
3
4
5 Min Delay Off
Low/Medium/High/Off
Tornado II & Tornado III Use, Care, and Installation Guide
Blower On/
Power Off
Blower On / Speed Selection
1
Press
Blower On / Power Off
2
By pressing
again and the entire hood will power off, including lights.
Delay Off
3
By pressing
appear in the lower right corner of the hood display
is on. The blower will change to speed 1 and shut down after 5 minutes.
Lights Low/Medium/High/Off
4
Switch lights to low by pressing
times for high, and again to switch off.
Features & Controls
to power on blower and cycle through all three blower speeds.
, the blowers will power on at the last speed setting. Press
, the blower and lights will enter Delay Off mode. A dot will
once, pressing two times for medium, three
indicating the function
19