Disposal - DS Produkte MT20188 Mode D'emploi

Circuit de course tube racer
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
Problem
The car stops on the
race track.

Disposal

The packaging material, tubes and connectors should be recycled.
This article is governed by the European Directive 2012/19/EU on waste electrical
and electronic equipment (WEEE). Do not dispose of this device as normal
domestic waste, but rather in an environmentally friendly manner via an offi cially
approved waste disposal company.
Rechargeable and non-rechargeable batteries should not be disposed of in the
normal household waste. They should be removed prior to disposal of the remote
control and disposed of at suitable collection points.
Customer Service / Importer:
DS Produkte GmbH
Am Heisterbusch 1, 19258 Gallin, Germany
Tel.: +49 38851 314650 *
*) Calls to German landlines are subject to charges. The cost varies, depending on the service
provider.
All rights reserved.
22
Possible cause
The tube halves have not
been fi tted together correctly.
The tube connection has
gaps. There must be no
gaps between the tube ends.
When using a cross-connec-
tor (add-on set): The open-
ing in the cross-connector is
facing downwards.
When using a cross-connec-
tor (add-on set): The speed
of the cars is too low.
Fix
The two tube halves must form
a smooth ring and the connec-
tors must be engaged.
The tube ends must be pushed
into the connectors until they
contact one another. Turn the
connectors until the locking
lugs of the tubes are in the slots
in the connectors. This fi xes the
connection in place.
The opening must be facing
upwards.
Increase the speed.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

01155

Table des Matières