Use - DS Produkte MT20188 Mode D'emploi

Use

• If the car performance becomes weaker or the LEDs no longer light up, its battery
must be recharged (see the "Charging the car battery" chapter).
• If the car does not react to the remote control although it is fully charged, or if the
indicator light on the remote control does not light up when the
pressed, the batteries in the remote control have to be replaced (see the "Inserting
batteries" chapter).
19
1. Switch on the car: Slide the ON / OFF switch to the ON
position. The LEDs start to fl ash.
2. Switch on the remote control: Slide the ON / OFF switch
to the ON position.
3. Open the door in the race track, pressing slightly against
the door lock.
4. Place the car into the tube.
5. Close the door.
6. Point the infrared transmitter of the remote control to-
wards the car and press one end of the
depending on the desired direction of travel. The car then
starts. The car stops as soon as you release the switch.
7. When not in use, switch off both the car and the remote
control with the ON / OFF switch (OFF position).
EN
toggle switch,
toggle switch is