Setting Up The Race Track - DS Produkte MT20188 Mode D'emploi

EN

Setting up the race track

PLEASE NOTE
■ CAUTION – Danger of Injury! Do not set up the race track on stairs or other places
where there is a risk of tripping.
B
A
Separating connectors and tubes
Pull the parts slightly apart, turning slightly until the locking lugs slide out of the recesses
in the connector.
18
1. Fit two matching tube halves precisely together. All the
clips must engage and the tube profi le must form a
smooth ring.
2. Push a connector onto one end of the tube and turn it
slightly until the locking lugs (A) on the end of the tube en-
gage in the corresponding recesses (B) in the connector.
3. When the connector is fully on the end of the tube, turn it
slightly to lock it in place.
4. Assemble all the tubes and connectors according to your
wishes. Ensure also that the tubes with the door are in-
stalled. The race track should form a closed circuit so
that the car cannot fl y out at high speed and create a
risk of injury.