Checking the Standard Accessories
Check to make sure that you have all the standard accessories before assembly and installation.
Base cover x 1
•
Screws (4 x 10 mm) x 4
•
1
Installation bolts
•
(M8 x 20 mm: black) x 2
Assembling the Stand
Assembly Procedure
1
Turn the base cover over so the
underside is facing up.
2
Insert the stand pipes into the base
cover.
3
Tighten the screws to stabilize the
stand pipes.
Stand pipes
•
(left and right, interchangeable) x 2
2
Installation bolts
•
(M8 x 40 mm: black) x 2
Screws
(4 x 10 mm)
Base cover
Hexagonal wrench x 1
•
(Opposite side 6 mm for M8 use)
Operating instructions
•
(this document) x 1
Table top stand
Pied de table
PDK-1016
Operating instructions
Mode d'emploi
Stand pipe
Stand pipe
Screws
(4 x 10 mm)
3
En