Attaching The Plasma Display - Pioneer PDK-1016 Elite Mode D'emploi

Attaching the Plasma Display

Caution
The weight of a Plasma Display is about 34.1 kg (75.2 lbs), it
has no depth, and are unstable. Therefore, at least two
people must assemble and install them.
Note
Insert the bolts in the holes vertically and do not tighten
them with more force than necessary.
Place a sheet or protective cover to protect the display from
scratches or damage.
Assemble only with the Plasma Display lying flat on a table
or similar surface.
Move the stand so that the stand screw holes and the nuts
that connect the main display line up correctly.
1
With the Plasma Display lying flat, insert and
secure the two Installation bolts 1 (M8 x 20
mm: black) in the holes "a" located in center of
the Plasma Display housing.
At this point, tighten these bolts 1 only until the threads
are no longer visible when viewed from the side (you will
be unable to attach the display if the bolts are screwed in
completely).
Installation
1
bolt
Plasma Display
housing
Plasma Display
Sheet
Note
When laying down the Plasma Display, be careful so as to not
scratch or damage it.
4
En
2
3
Stop screwing
4
down the bolt
when the threads
are no longer
visible.
1
Installation bolt
(M8 x 20 mm: black)
Holes "a"
(holes in center
of Plasma
Display)
A
A´
As shown in the above figure, hook the stand
pipe holes A onto the screw heads of the instal-
lation bolts 1, then slide the stand upwards to
the main Plasma Display until it engages the
installation bolts 1 (once put together with the
display, the stand will slides no more than 19
mm (3/4 inch)).
Pass the installation bolts 2 (M8 x 40 mm:
black) through the stand pipes and tighten the
installation bolts firmly with the accessory
hexagonal wrench (The holes should be used in
the proper combinations, A–A').
Be sure to tighten the bolts securely.
Tighten the installation bolts 2 firmly with the
accessory hexagonal wrench.
Be sure to tighten the bolts securely.
Table top stand
Not applicable
to this model.
A
A´
2
Installation bolts
(M8 x 40 mm: black)
(Step 3)
Slide the stand
(Step 2)