Preventing Equipment From Falling Over - Pioneer PDK-1016 Elite Mode D'emploi

Preventing Equipment from Falling Over

After installing the stand, be sure to take special care to ensure that the equipment will not fall over.
Because of the plasma display's weight, if it could fall down, this can result in injury.
For safety, be sure to take special care to ensure that the Plasma Display will not fall over.
Stabilizing on TV table or other location
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
To stabilize the Plasma Display on a TV table, use screws that
have a nominal diameter of 6 mm (1/4 inch).
Select the appropriate screws after consulting a professional
installer if necessary.
Position of table screws
To stabilize the Plasma Display on a TV table, use screws
that have a nominal diameter of 6 mm (1/4 inch).
Unit: mm (inch)
Dimension without speakers
6
En
Min. 20 mm
(13/16 inch)
120
(4-23/32)
552 (21-23/32)
Side View
Using a wall for stabilization
1
Attaching falling prevention bolts (hooks) to
the Plasma Display.
2
Using strong cords to firmly stabilize it
appropriately and firmly to a wall, pillar, or
other sturdy element.
Perform this work in the same way on the left and right
sides.
Note
Use hooks, cords, and fittings that are
available on the market.
Recommended hook:
Nominal diameter M8
Length 12 mm to 15 mm (1/2 inch to
5/8 inch)
1
Hook
2
Cords
Fittings
Caution
• A TV table with adequate strength should always be
used to support the Plasma Display.
Failure to do so could result in personal injury and
physical damage.
• If you do not take these precautions, the Plasma
Display could fall down and cause injury.
• The screws, hooks and other fittings that you use to
secure the Plasma Display to prevent it from
overturning will vary according to the composition and
thickness of the surface to which it will be attached.
• Select the appropriate screws, hooks and other fittings
after first inspecting the surface carefully to determine
its thickness and composition and after consulting a
professional installer if necessary.
12 mm to 15 mm
(1/2 inch to 5/8 inch)