Checking The Standard Accessories; Assembling The Stand - Pioneer PDK-1015 Mode D'emploi

Checking the Standard Accessories

Check to make sure that you have all the standard accessories before assembly and installation.
• Note that a Phillips screwdriver (not included) is required for assembly.
Base cover x 1
Screws
(M5 x 10 mm: silver) x 6

Assembling the Stand

Assembly Procedure
1
Turn the base cover over so the underside
is facing up.
Note
When the base cover is turned over, be very careful not
to scratch or damage the front surface of the base cover.
2
Insert the stand pipes into the base cover.
3
Tighten the screws to stabilize the stand
pipes.
Note
Assemble the stand with a soft sheet placed under the
base cover.
If a sheet is not laid before assembly, the front surface of
the base cover may be scratched.
Due to the manufacturing process of the base cover, there
may be a "weld line" exposed in the plastic. Note that this
will not cause any damage to the product, and does not
reflect any flaws in the product design.
Stand pipes
(left and right, interchangeable) x 2
Installation bolts
(M6 x 20 mm: black) x 4
Base cover
Cable clamps x 2
Operating instructions
(this document) x 1
Table top stand
Pied de table
PDK-1015
Operating instructions
Mode d'emploi
Screws
(M5 x 10 mm: silver)
Stand pipe
Screws
(M5 x 10 mm: silver)
Sheet
Stand pipe
3
En