Preparation - Nakayama PS2700 Traduction De La Notice Originale

2. Keep all parts of the body away from the saw
chain. Do not remove cut material or hold
material to be cut when saw chain is moving.
Make sure the product is switched off when
clearing jammed material. A moment of
inattention while operating the product may
result in serious personal injury.
3. Hold the product by insulated gripping
surfaces only, because the saw chain may contact
hidden wiring. Saw chains contacting a "live" wire
may make exposed metal parts of the product
"live" and could give the operator an electric
shock.
4. Keep all parts of the body away from the saw
chain when the product is operating. Before
you start the product, make sure the saw
chain is not contacting anything. A moment of
inattention while operating this product may
cause entanglement of your clothing or body
with the saw chain.
5. Always hold the product with your right hand
on the rear handle and your left hand on the
front handle. Holding the product with a reversed
hand configuration increases the risk of personal
injury and should never be done.
6. Wear safety glasses and hearing protection.
Further protective equipment for head, hands,
legs and feet is recommended. Adequate
protective clothing will reduce personal injury by
flying debris or accidental contact with the saw
chain.
7. Do not operate the product in a tree. Operation
of a product while up in a tree may result in
personal injury.
8. Always keep proper footing and operate the
product only when standing on fixed, secure
and level surface. Slippery or unstable surfaces
such as ladders may cause a loss of balance
or control of the product.
9. When cutting a limb that is under tension be
alert for spring back. When the tension in the
wood fibres is released the spring loaded limb
may strike the operator and/or throw the product
out of control.
10. Use extreme caution when cutting brush and
saplings. The slender material may catch the saw
chain and be whipped toward you or pull you off
balance.
11. Carry the product by the front handle with
the product switched off and away from your
body. When transporting or storing the product
always fit the guide bar cover. Proper handling
of the product will reduce the likelihood of
accidental contact with the moving saw chain.
12. Follow instructions for lubricating, chain
tensioning and changing accessories. Improperly
tensioned or lubricated chain may either break or
increase the chance for kickback.
13. Keep handles dry, clean, and free from oil and
grease. Greasy, oily handles are slippery causing
loss of control.
14. Cut wood only. Do not use the product for
purposes not intended. For example: do not use
the product for cutting plastic, masonry or non-
wood building materials. Use of the product for
operations different than intended could result in
a hazardous situation.
15. Pay attention to national and local
regulations. National and local regulations may
restrict the use of this product.
16. Remove branches in sections.
17. Beware of dangerous operating positions
as well as of the risk of being struck by falling
branches or by those that rebound after hitting
the ground.
18. Beware of overhead power lines. Do not use
the product in any position that causes any part
to come within 10m of overhead electrical lines.
19. Never cut in areas where the cutting
attachment is out of sight.

Preparation

1. This product can cause serious injuries. Read
the instructions carefully for the correct
handling, preparation, maintenance, starting and
stopping of the product. Become familiar
with all controls and the proper use of the
product.
2. Never allow children to use this product.
3. Avoid operating while people, especially
children, are nearby.
4. Dress properly! Do not wear loose clothing or
jewellery, which can be caught in moving
13