Dreame Aero Pro Mode D'emploi page 11

Starting Cleaning
1. Remove the tank.
4. Gently step on the floor brush
and recline the appliance
backwards. Briefly press the
power switch button to
start/stop operating.
Note:
• Do not vacuum any foamy liquids.
• The appliance is suitable for cleaning floors, marble, tiles and other hard surfaces.
• When the appliance is in operation, do not lift it off the ground, move it or tilt it.
Otherwise, the used water may flow into the motor.
Add Cleaning Fluid
To reduce the risk of fire and electric shock due to internal component damage,
use only Dreame Trading (Tianjin) Co., Ltd. AWH10 cleaning fluid intended for use
with the appliance.
1. Remove the seal before use.
2. Measure the floor cleaner with the bottle cap (*approximately 10 ml/0.34 fl oz
per cap).
3. Pour it into the clean water tank and gently shake to mix it evenly before use.
Note: Do not add any liquids other than the officially-approved cleaner. The
cleaner can be available on the official online store. Refer to the cleaning solution
label for specific usage instructions.
1
2. Open the tank cover
and fill the tank with clean
water.
4
5. Briefly press the mode
switch to switch modes
according to your needs.
2
3. Reinstall the clean water
tank until it clicks.
5
EN
Click
3
7 7