Velleman CCTVPROM17 Guide D'installation Rapide page 6

7. Operation
Display
The following image shows the screen layout.
live audio from audio channel 1–4 (indicated
in white)
audio channel unselected
digital zoom on (yellow) / off
LAN connected / internet connected / no network connection
USB flash drive connected
key lock on
sequence mode
recording mode
administrator logged on
Note that actual screen icons might differ slightly from the ones shown above.
Quick Menu Bar
Note: Only available when USB mouse is connected.
Move the mouse pointer to the left of the screen to extend the quick menu bar and show the functions:
Open channel switch panel.
Show playback control panel.
Zoom-in mode (select desired channel first before entering zoom mode).
Select audio channel (live mode only live channels can be selected).
Enter PTZ mode and show PTZ control panel.
Recording
1. Check whether the camera(s) is (are) properly connected and a HDD is present inside the device.
2. If the auto-recording and pre-alarm functions are enabled, the device will start recording images.
o By default, the recording icon (
o If the motion or alarm detection is activated and a motion or alarm is detected, the motion (
displayed.
o If timer recording is enabled, the timer recording icon (
o By default, the device is in HDD overwrite mode and the icon (
Playback
Make sure the control panel is not locked and press the PLAY button on the control panel or use the quick menu bar to open
the playback control panel:
Note: There must be at least 8192 images of recorded data for playback to work properly. If not, the device will stop
playback. For example, if the IPS is 30, the recording time should be at least 273 seconds (8192 images / 30 IPS) for the
playback to work properly.
 Increase or decrease the playback speed using the fast forward (
speed forward/backward, click twice to get 8x speed, etc. Maximum speed is 32x.
 Press the pause button (
V. 03 – 05/05/2014
CCTVPROM17
A system date and time
B general system status
C available HDD capacity
D channel status
) is displayed.
) to pause playback.
playback audio from audio channel 1–4 (indicated in
yellow)
timer recording on
USB mouse connected
overwrite on (default)
PTZ mode
motion mode
alarm mode
operator logged on
) is displayed.
) is displayed.
A progress bar
B control bar
C event search
D information bar
E close
) and fast rewind (
6
) resp. alarm ( ) icon is
) buttons. Click once to get 4x
©Velleman nv