Appendix A1 - A3; A1 Synchronization; A2 Reset; A3 Maintenance - REICH MoveControl Compact Instructions D'assemblage Et Mode D'emploi

Appendix A1 - A3

A1 Synchronization

Following a malfunction or after exchanging an
electronic part a synchronization procedure must
be carried out. Proceed as follows and avoid
pauses of more than 2 seconds:
If necessary turn the remote control
OFF = push one time
System ON = turn isolation switch on
Reset-button = push and hold!
Handset turn ON = Double click
LED remote control
LED basic station
Handset turn OFF = push one time
LED remote control
LED basic station
Release reset-button
The synchronization is completed.
Attention! Avoid pauses of more than 2
seconds during
otherwise the synchronisation has to be
restarted.
After approx. 20 seconds, the remote control will
be switched-off automatically, if there were no
entries!
On
Off
the synchronization,

A2 Reset

The reset process is only required if the LED of
the E-box is eluminated. This is an error signal
(for example overload) - the LED is usually off.
When resetting the overload protection reverts to
its normal position.
Turn ON handset = Double click
Reset-button = push
LED basic station
Turn OFF handset = single click
The reset process is complete.
Attention! If the LED does not go out after
repeating reset procedure for several times,
please contact your dealer.

A3 Maintenance

A) At least once a year please have your
MoveControl maintained
inspected as described below:
- Cleaning of the complete drive unit.
- Application of suitable lubricant to all moving
parts (e.g. silicon spray).
- Check of the distance between the drive
rollers and the tyres as well as a checking the
tyre pressure.
- Visual inspection for damage of the cables
and the electrical connections.
- Check battery voltage.
B) Before moving please check if the moving
drive is free of dirt, sand and debris.
C) In case of failures or problems please contact
your supplier.
Off
and visually
GB11