REICH MoveControl Compact Instructions D'assemblage Et Mode D'emploi page 29

5. Installation electrical
Make sure that you never exchange
the Positive (+) and Negative (-) of
the electricity supply!
Make sure that all cables are installed properly,
solidly and without any friction.
Carefully seal any holes with suitable sealing
material, from the inside and the outside.
E5 Basic station
Fix the housing lid of the Basic Station.
Mount the antenna cable in accordance with the
notes on the Basic Station. If the radio signal
reception is poor,
antenna to 54 cm The cable should be taken
outside the vehicle taking care that the aerial
does not come into contact with any metal parts.
E6 Connection D-Plus (Safety circuit)
If the D-Plus signal of the vehicle has been
connected to the contact and a signal is supplied,
the MoveControl cannot be started. This kind of
safety circuit prevents any operation being not
appropriate.
E7 Connection battery
Now connect the 10 mm² cables to the
battery. The electrical
completed.
then you extend
installation is now
the
GB7